《Nuclear Disaster Sun and Moon》Episode 2 plot introduction

Today I would like to recommend a drama to you - Nuclear Disaster Sun and Moon -. At first glance, it is quite entertaining. The actors are also good-looking. Although the acting is a bit exaggerated, the plot is light-hearted and suitable for everyone to pass the time.Everyone has also expressed some doubts about the plot introduction of the second episode of the plot - Nuclear Disaster Sun and Moon. Today, the editor will take you to take a look.

The isolating condenser, referred to as the "condenser", will automatically activate during a power outage to cool the nuclear reactor. It can still play a cooling role within eight hours with the help of batteries. However, because all control instruments cannot operate, the staff cannotVerify that the nuclear reactor is still cooling.

Factory Director Yoshida decided that the first thing to do was to restore power, and asked the headquarters to send several mobile generators and notify the fire trucks, because if power could not be restored, the reactor would have to be cooled with water from the outside.The Nuclear Energy Emergency Preparedness Special Measures Act stipulates that residents must be evacuated urgently in such situations. However, the government immediately announced that no radiation leakage had been detected and recommended that people stay at home without evacuation.

The supervisors on duty at Unit 1 and Unit 2 sent people to check inside the steam turbine building of Unit 1. Unexpectedly, the radiation detectors started buzzing before they even got close to the nuclear reactor. If the radiation level was already so high, it would be necessary to establishA water injection pipeline will only become more difficult. At this time, senior veteran Furuya volunteered to operate it, and also brought a full-face mask obtained from the isolation building.

Under the leadership of Furuya, the group re-entered the No. 1 reactor plant and opened all the valves. On the other hand, a high-voltage mobile generator arrived at 9:50 pm, but the switchboard needed to be depressurized.The switchboards of the nuclear power plant were all flooded with salt water, and they had to be checked one by one to know which ones were still working. With no other solution, the nuclear fuel began to melt at 10:20.

Director Yoshida sent a report to Tepco, saying that the reactor heating container would be damaged around 11:50, and nuclear fuel would begin to leak. The Prime Minister decided to immediately issue an evacuation order to evacuate the three-kilometer area around the Fukushima Nuclear Power Plant..

This article has compiled the plot introduction of the second episode of Nuclear Disaster Sun and Moon for those who are following Nuclear Disaster Sun and Moon, and provided some useful information.I hope this article can help everyone better understand - Nuclear Disaster Sun and Moon - and experience richer content and emotions.If you like this article and want to know more relevant information and plot analysis, you can continue to pay attention to our subsequent updates. For more exciting content, please look forward to the line class.